Surface Enrichment System

The SE contact system enables metallized particle interconnect to interface to a tin/lead surface. SE provides a means of interfacing LGA and BGA packages to the printed wire board (PWB) and works on both tin/lead pads on the PWB and eutectic solder balls on a BGA package. SE fulfills the low profile requirement of 5 mm stack height for notebook computers and is scalable to 0.8-mm pitch in pin counts from 400 to 5,000.

Thomas & Betts Corp.

Memphis, Tenn.


Easily post a comment below using your Linkedin, Twitter, Google or Facebook account. Comments won't automatically be posted to your social media accounts unless you select to share.

Leave a Reply

Your email address will not be published. Required fields are marked *


Introducing Semiconductor Digest
04/30/2019Semiconductor Digest is a new magazine dedicated to the worldwide semiconductor industry...
KLA-Tencor announces new defect inspection systems
07/12/2018KLA-Tencor Corporation announced two new defect inspection products at SEMICON West this week, addressing two key challenges in tool and process monit...
3D-Micromac unveils laser-based high-volume sample preparation solution for semiconductor failure analysis
07/09/2018microPREP 2.0 provides order of magnitude time and cost savings compared to traditional sample...