MEMSIC’s SmartSensing tech delivers highest performance in inertial measurement systems

MEMSIC announced the launch of its latest addition, the INS380, to its portfolio of Inertial Systems enabled with SmartSensing technology targeted to a broad range of precision motion sensing applications. The portfolio offering consists of Inertial Measurement Units (IMU), Vertical Gyros (VG), Attitude and Heading Reference Systems (AHRS), Inertial Navigation Systems (INS) and Tilt measurement systems in a variety of packages suited for system designers to end equipment manufacturers.

The latest product from MEMSIC, the INS380SA, is a complete inertial navigation system with a built-in 48-channel GPS receiver. The SmartSensing technology enables a turnkey system with better than 0.01 m/s velocity measurement accuracy. The integrated 3-axis magnetometer allows for accurate operation when the GPS signal is lost or when the vehicle comes to a stop.

SmartSensing technology provides users with sensor fusion and performance in critical motion sensing applications. SmartSensing combines enhanced and patented Kalman-based algorithm with proprietary temperature, motion and alignment calibration for consistent and high accuracy performance over a wide range of extreme operating conditions. Applications include unmanned ground and aerial vehicles, platform stabilization, avionics, precision agriculture, construction, and more.

“With over 400 man-years of design and development experience and knowledge in designing IMUs and sophisticated MEMS sensor solutions,” said Masoud Beheshti, VP and General Manager of MEMSIC’s system division. “MEMSIC is in a very unique position in the industry to help enable designer’s unprecedented size, accuracy and cost, with our SmartSensing technology.”

POST A COMMENT

Easily post a comment below using your Linkedin, Twitter, Google or Facebook account. Comments won't automatically be posted to your social media accounts unless you select to share.

Leave a Reply

Your email address will not be published. Required fields are marked *

NEW PRODUCTS

KLA-Tencor announces new defect inspection systems
07/12/2018KLA-Tencor Corporation announced two new defect inspection products at SEMICON West this week, addressing two key challenges in tool and process monit...
3D-Micromac unveils laser-based high-volume sample preparation solution for semiconductor failure analysis
07/09/2018microPREP 2.0 provides order of magnitude time and cost savings compared to traditional sample...
Leak check semiconductor process chambers quickly and reliably
02/08/2018INFICON,a manufacturer of leak test equipment, introduced the UL3000 Fab leak detector for semiconductor manufacturing maintenance teams t...