Leti reports FinFET feasibility and circuit design with CoolCube tech

CEA-Leti today announced its first results towards the demonstration of CoolCube’s feasibility in FinFET technology on its 300mm production line, and new CoolCube circuit designs that improve the trade off between area, speed and power.

Key process steps developed on 300mm wafers show progress in closing the gap between the demonstration of a single device and taking the technology to fabrication.

CoolCube is Leti’s sequential integration technology that enables the stacking of active layers of transistors in the third dimension. Under development for eight years, it aims at fully benefiting from the third dimension, and is enabled by cutting in half the thermal budget in manufacturing transistors, while maintaining their performance.

Mobile devices, where minimal power consumption is key, are the primary market for chips manufactured with the technology. CoolCube also allows designers to include backside imagers in the chips, and co-integration of NEMS in a CMOS fabrication process also is possible.

“CoolCube enables local via density that is 10,000 times higher than ‘standard’ 3D integration, because the technology is designed to connect stacked active layers at a nanometric scale,” said Maud Vinet, Leti’s advanced CMOS laboratory manager. “In the digital area, we expect this 3D technique to allow a gain of 50 percent in area and 30 percent in speed compared to the same technology generation in classic 2D – gains comparable to those expected in the next generation. In heterogeneous integration, we expect CoolCubeTM to be an actual enabler of smart-sensor arrays by allowing a close integration of sensors, detection electronics and digital signal processing.”

Leti’s team will be in the European PavilionSouth Hall, Booth #2317, during SEMICON West.

Leti feature 1

Leti’s CoolCube is made possible by sequential integration.

POST A COMMENT

Easily post a comment below using your Linkedin, Twitter, Google or Facebook account. Comments won't automatically be posted to your social media accounts unless you select to share.

Leave a Reply

Your email address will not be published. Required fields are marked *

NEW PRODUCTS

KLA-Tencor announces new defect inspection systems
07/12/2018KLA-Tencor Corporation announced two new defect inspection products at SEMICON West this week, addressing two key challenges in tool and process monit...
3D-Micromac unveils laser-based high-volume sample preparation solution for semiconductor failure analysis
07/09/2018microPREP 2.0 provides order of magnitude time and cost savings compared to traditional sample...
Leak check semiconductor process chambers quickly and reliably
02/08/2018INFICON,a manufacturer of leak test equipment, introduced the UL3000 Fab leak detector for semiconductor manufacturing maintenance teams t...