Extreme Ultra-Violet Lithography (EUVL) keeps hurting my brain. Just when I can understand how it could be used in profitable commercial high-volume manufacturing (HVM) I hear something that seriously strains my brain. First it was the mirrors and mask in vacuum, then it was the resist and pellicle, then it was the source power and availability, and in each case scientists and engineers did amazing work and showed a way to HVM. Now we hear that EUVL might require fabs to park work-in-progress (WIP) lots of wafers behind a single critical tool with an idealistic 80% availability on a good day, and lots of downtime bad days. Horrors!
For “5nm-node” designs the maximum allowable edge placement-error (EPE) in patterning overlay is only 2nm. While the physics of ~13.5nm wavelength EUVL means that aberration in the reflecting mirrors appears as up to 3nm variation in the fidelity of projected patterns. This variation can be measured and compensated for at the physical mask level, but then each mask would only be good for one specific exposure tool. John Sturtevant—SPIE Fellow, and director of RET product development in the Design to Silicon Division at Mentor Graphics—briefly discussed this on February 26th during Nikon LithoVision held just before SPIE Advanced Lithography.
Sturtevant explained that the Zernike coefficients for EUV are inherently almost 1 order-of-magnitude higher than for DUV at 193nm wavelength, as detailed in the SemiMD article “Edge Placement Error Control in Multi-Patterning.” How the inherent physical sources of aberration must be tightened to avoid image distortion and contrast loss as they scale with wavelength was discussed by by Fenger et al. in 2013 in the article “Extreme ultraviolet lithography resist-based aberration metrology” (doi:10.1117/1.JMM.12.4.043001).
The Intel/Micron joint-venture now claims to have successfully integrated a Resistive-RAM (ReRAM) made with an unannounced material in a cross-point architecture, switching using an undisclosed mechanism. Pilot production wafers are supposed to be moving through the Lehi fab, and samples to customers are promised by end of this year. HP Labs announced great results in 2010 on prototype ReRAM using titania without the need for a forming step, and then licensed the technology to Hynix with plans to bring a cross-point ReRAM to market by 2013. SanDisk/Toshiba have been working on ReRAM as an eventual replacement for NAND Flash for many years, with though a bi-layer 32Gb cross-point ReRAM was shown at ISSCC in 2013 they have so far not announced production.
Let us hope that the folks in Lehi have succeeded where HP/Hynix and SanDisk/Toshiba among others have so far failed in bringing a cross-point ReRAM to market…so this may be a “breakthrough” but it’s by no means “revolutionary.” Until the Intel/Micron legal teams decide that they can disclose what material is changing resistance and by what mechanism (including whether an electrical “forming” step is needed), the best we can do is speculate as to even how much of a breakthrough this represents. —E.K.